 | |
 |  |
Mercury V SSM
| The V SSM drive uses the same transom assembly as the III-A SSM. The installation height is 6" (152.4 mm) shorter than the III-A Drive. |
 |
 | Net Forged upper gears (some ratios) |
| Large vertical bearings in upper gear housing (better gear support) |
| Large vertical driveshaft (resist twisting) |
| Large pinion bearings (better gear and shaft support) |
| Redesigned lower housing improves water flow and boat handling. |
| Rated for750 hp and up to 750 ft lbs of torque, we have used it successfully on up to 1000 HP |
| Spacers available to lower drive unit up to 3 inches in 1 inch increments. |
| Gear ratios: (RH or LH) 1:1, 1.18:1, 1.33:1, 1.48:1, 1.62:1 |
Call for pricing
